  /**
  @addtogroup PORT_Joystick_LEDs_3T PORT_Joystick_LEDs for MDR1986VE3 evaluation board
  @latexonly
  @verbatim
  ******************** (C) COPYRIGHT 2024 Milandr ***********************************
  * @file    readme.txt
  * @author  Milandr Application Team
  * @version V2.0.0
  * @date    02/08/2021
  * @brief   Description of the PORT_Joystick_LEDs Example.
  ******************************************************************************
  * THE PRESENT FIRMWARE IS FOR GUIDANCE ONLY. IT AIMS AT PROVIDING CUSTOMERS
  * WITH CODING INFORMATION REGARDING MILANDR'S PRODUCTS IN ORDER TO FACILITATE
  * THE USE AND SAVE TIME. MILANDR SHALL NOT BE HELD LIABLE FOR ANY
  * DIRECT, INDIRECT OR CONSEQUENTIAL DAMAGES RESULTING
  * FROM THE CONTENT OF SUCH FIRMWARE AND/OR A USE MADE BY CUSTOMERS OF THE
  * CODING INFORMATION CONTAINED HEREIN IN THEIR PRODUCTS.
  ******************************************************************************
  @endverbatim
  @endlatexonly

@par Example Description

This example shows how to use input/output ports.
PORTG is configured for input. Its 7, 11, 12, 13, 14, 15 pins are connected to the joystick buttons.
PORTB is configured for output. Its 0..5 pins control LED indicators.


@par Directory contains:

    - main.c   Main program


@par Hardware and Software environment:

    - This example is intended to run on MDR1986VE3 eval board with MDR1986VE3 microcontroller.
    - "SEL", "UP", "DOWN", "LEFT", "BACK" and "RIGHT" joystick buttons are connected to
      PG.7, PG.11, PG.12, PG.12, PG.13, PG.14, PG.15 pins, respectively.
    - VD5, VD6, VD7, VD8, VD9, and VD10 LEDs are connected to
      PB.0, PB.1, PB.2, PB.3, PB.4 and PB.5 pins, respectively.


@par How to use.

To launch the example, you must do the following:
    - Create a project and setup all project configurations.
    - Add main.c file.
    - Add the required files from "Libraries" folder:
        MDR32F9Qx_config.h
        MDR32F9Qx_port.c
        MDR32F9Qx_rst_clk.c
    - Edit the MDR32F9Qx_config.h to set appropriate run-time parameter checking level.
    - Compile and link together all .c files and load your image into the target board.
    - Run the example.

 * <h3><center>&copy; COPYRIGHT 2024 Milandr</center></h3>
 */

